CreateNewStuff.com Your home for handy things

TI Breakout Board - AM3517

This adapter is designed to expand the three 100 pin high density connectors (Hirose DF40C-100DS-0.4V(51)) to manageable 0.100" connectors on the Texas Instruments AM3517 EVM and Logic PD Experimenter kits.  The adapters are sold as pre-assembled boards so you can plug-n-play out of the box.  No soldering required.

The adapter maps each pin on the small connector to the larger connectors in a one-to-one fashion so it can be used universally on all 3 of the baseboard connectors.  If you are just getting started with one of these kits, we recommend purchasing one adapter per kit.

The adapter can be secured to the baseboard using nylon screws and nuts using the baseboard and adapter mounting holes.

On the AM3517 kits, you can access all the signals on J21, J22, and J23 enabling access to:

J21: Display SubSystem(DSS), CCDC, UART1 UART2, UART3, SD port 1, SD port 2
J22: GPMC bus, I2C2, I2C, McBSP1, McBSP2, SPI1, SPI2,
J23: McBSP3, McBSP4, I2C1, Power Management I2C, Reset Output, WL1271 UART for Wifi & BT debug, JTAG signals, Boot control pins, ETK signals

Schematic is here:  Breakout_Adapter_AM3517.pdf

Click here for international orders. 

 

High Resolution:

Top View, Bottom View


 Fully populated board: 0 in stock, short lead time to build.
Select Quantity

 

High Resolution:

Top View, Bottom View

 High-density connectors populated only: 6 in stock 

Select Quantity